Pony Enterprises, Inc. is a manufacturer / wholesale distributor of restoration and maintenance hardware and fasteners for classic cars. We have been serving the Mustang community since 1981.
This set of screw rivets attaches the fabric lining to the inside of your Mustang's trunk. Hardware is for 1983-1993 Mustang Convertibles.
Set includes six screw rivet-retainers.
Phillips screws expand the plastic retainers as…
This complete hardware kit attaches the cowl vent grille to your 83-93 Mustang.
Kit includes:
Four plastic retainers (Fit into sheet metal of cowl)
Six 1" screws (w/ plain-dish washers)
…
•Fits all 1979-1993 Mustangs
•Sold as a pair
•Enough to do one door handle
1979 1980 1981 1982 1983 1984 1985 1986 1987 1988 1989 1990 1991 1992 1993 hardware
…
This rivet affixes the door lock actuator to the inner door frame.
Set includes one 2-1/8" rivet with reverse-beveled washer.
1979 1980 1981 1982 1983 1984 1985 1986 1987 1988 1989 1990 1991 1992 1993
…
This kit replaces the hardware that attaches your battery tray to your inner fender.
Kit includes:
Two 1" hex-head bolts w/ washers
One 2-1/4" hex-head Battery Hold-down bolt
One U-nut
1986 1987 1988 1989 1990 1991 1992 1993 …
•Brand new
•Fits 1979-1993 Mustang
•Hardware to attach the lower shift boot to the transmission tunnel
• oxide coated for corrosion resistance
•Includes 4 clip nuts and 4 bolts
…
• Fits any 1979-1993 Mustang
• These plugs seal the drain plugs in the front floorpan located just before the rise on 1979-1993 Mustangs
• Keeps dirt and water out of your interior!
• Sold as a set of 4 (Enough to do…
When your dash panel screws start to wear, the dash panel can become loose and wobbly causing noise in the interior of your Mustang. Thesescrews are a high quality reproduction and will perfectly replace the originals.
…
These white nylon clips are attached via rivets and allow the door belt moldings to be properly installed.
Kit includes eight clips.
Four per door, eight per car.
…
Kit includes:
2 Door Hinge Pins
4 Hinge Bushings
2 Retaining Pins
• Fits 1979-1993 Mustangs
• This kit will complete one door
• Replace your old or broken door hinge hardware
1979 1980 1981 1982 1983 1984 1985…
•This screw & nut set attaches the door armrest to the door frame on 1987-1993 Mustangs.
•This complete hardware kit installs one armrest, two kits per car.
Kit includes:
•Two 1-3/4" long hex-head screws, Stainless…
•Brand New
•Fits all 1985-1993 Mustangs
•Attaches the "Ford" blue oval emblem to the front bumper cover to keep it securely installed
•Includes two teethed nuts …
•Brand New
•Fits all 1989-2004 Mustangs & Cobras
•This item replaces the radiator bumper
•Radiator bumper is hexagonal, bolt is threaded
•Does not include fastening knot
…
•Brand new
•Fits 1981-1996 Mustangs
•Screws hold the door armrest pads to the door
•Works for both power or manual equipped doors
•Set of 6 screws
•Kit does both doors (LH & RH)
•Direct replacement for OEM…
•Brand New
•Fits all 1983-1986 Mustangs and 1987-1993 Mustang GTs & Cobras
•This item contains the necessary parts to replace the retainers and sealer on your taillight. Keep moisture out of your taillight!
•Sold as a…
This hardware kit mounts ground-effect side skirts to your 87-93 Mustang GT.
Kit includes twenty-two 1-7/8" rivets.
Mounts one side only.
Mounts aftermarket & OEM skirts.
…
•Brand New
•Fits ANY 1979-1993 Mustang hardtop
•Not intended for convertibles
•Sold as a set of 4 (enough to do one car)
•Holds headliner in place
•Measures 1" wide x 3/4" tall …
This is a hardware kit that is used in multiple places in your Mustang. These retainers secure many wiring harnesses, and tape must be used to attach them.
Kit includes five white plastic clips with Christmas tree plugs. …
These plugs repair & replace the seals that are located on the left and right sides of the floor pan underneath the front seats. Two plugs per side. Keep dirt and water out of your interior!
Set includes four rubber…
•Brand new
•This is the small clip that retains the windshield wiper linkage to the windshield wiper motor
•Originals are often broken or lost
• oxide coating for corrosion resistance
•Direct replacement for 1974-1993…
•Brand New
•Fits all 1986-1993 Mustangs
•This hardware kit contains Six U-nuts that clip to the inner fender and allow the fender bolts to be screwed in
…
This item contains the necessary parts to replace the retainers and sealer on your tail light. Keep moisture out of your tail light!
Kit includes:
One strip of rubber sealer (w/ butyl tape)
Twelve rectangular retaining…
• For 1987-1993 Mustang LX models without fog lights
• Replaces broken or worn plug and pigtail
• Rectangular 6-pin connector
• Pigtail has eight 7" long wires for easy splicing
1987 1988 1989 1990 1991 1992 1993…
• Fits 1987-1993 Mustang Coupe (Notchback)
• Includes all screws to do the entire interior
• Complete with 92 pieces
Includes the following screw kits:
•kick panel (2)
•scuff plate (8), door speaker grille (2)…
•Brand new
•Fits ANY 1987-1993 Mustang GT & 1993 SVT Cobra (Does not fit Cobra R)
•This is the connector that plugs into the back side of your Headlight/Fog light switch
•Headlight plug is a rectangular 6-pin…
•Brand New
•Fits ANY 1979-1986 Mustang
•Includes Seven (x7) Plastic Retainers & Seven (x7) Metal Nuts
•Enough to do one door
•Replaces your worn or broken door molding retainers
•These pieces mount to the top…
•Brand New
•Fits ANY 1979-1993 Mustang or Cobra
•Includes Eight (x8) Retainers (Enough to do one car)
•These retainers secure the splash shields to the fender wells
•Easy Push-In Installation
•Retainers measure…
This hardware replaces the bolt that assists in keeping the battery secure in your 1986-1993 Mustang.
Kit includes one 2-1/4" hex-head bolt w/ washer.
…
•For 1979-1986 Mustang Hatchback
•Includes all screws to do the entire interior
•Complete with 163 pieces
Includes the following screw kits:
•quarter panel (8), rear seat hinge (7), rh dash housing (1), upper A…
• For 1979-1993 Mustangs
• Secures the sill plates to the door frame
• Chrome plated for that upgraded look
• Enough for both left and right side sill plates
Set includes:
Eight 1-1/2" Phillips screws (Pan-head…
• For 1979-1993 Mustang sill plates
• Sold as an 8-piece set, enough to do both sill plates
• Screws are black, fitted for phillips head, and are 1.5" long
1979 1980 1981 1982 1983 1984 1985 1986 1987 1988 1989 1990…
This hardware kit contains the items necessary to install the front and rear license plates on your 1979-2004 Mustang.
Kit includes:
Four 7/8" Flathead screws (Stainless Steel, w/ fixed washers)
Two white plastic retaining…