Your shopping cart is empty!
DRIVEN BY CARE
-
My Account Sign In / Register
×
Select Your Vehicle to Shop for the Correct Parts:
Show More Filters
1-36 of 152 results for Lifestyle : Car Care, Protection & Tools : Tools : General Tools : All Productsgo
Sort by
Show
Show results for
Refine By
Availability
On Sale
Condition
Price
Under $10 (8)$10 to $25 (22)$25 to $50 (36)$50 to $100 (46)$100 to $250 (22)$250 to $500 (16)$500 & Above (2)
$ to $ go
Manufacturer
Show Less Filters
Model: 3166966
Condition: NEW
Manufactured by Nu-Rex, this handy tool makes timing the Model A a breeze! Simply insert your timing pin and rotate the cam using this wrench until it rests against the specified contact on the distributor body and your done! Instructions…
Model: 3149033
Condition: NEW
A handy tool to tighten the water pump pack nut. One word of caution--adjust it very carefully and only a little at a time, just enough to stop the leak. U.S.A.…
Model: 3234484
Condition: NEW
A well made cast aluminum heat treated tool set for the Model A gas gauge. Will not damage the chrome nuts. U.S.A.…
Model: 3205176
Condition: NEW
These tools are required for repairing/removing/installing the Model A gas gauge assembly. The square tool pictured removes/installs the inner nut, the other larger tool is used for the large outer nut of the gas gauge. This large tool is…
Model: 3134042
Condition: NEW
Product Overview
Tightly holds flashlight within easy reach.
Grey hammertone finish.
Fits up to 1-7/8" diameter steering columns.
Flashlight sold separately, item # c5013.
…
Model: 3237140
Condition: NEW
Slips around the ears of the light switch spider and gives you a large surface to push on so you can compress the spring to install the retainer. U.S.A.…
Model: 3232218
Condition: NEW
Sets over the distributor and theads into the female threads in the upper shaft where the screw that held the cam in place went. Pulls the distributur straight up so you don't take a chance on braking the casting by prying on it. U.S.A.…
Model: 3230668
Condition: NEW
To remove the fan, thread this special nut on the end of the pump shaft. By holding the fan and giving this tool a few good hits with the hammer, it will brake the fan blade loose from the shaft. U.S.A.…
Model: 3164434
Condition: NEW
Special tool for removing and installing the A-6259 cam nut. U.S.A.…
Model: 3163611
Condition: NEW
Bracket in this kit bolts to the flywheel. The flywheel is then turned so you can be sure the flywheel housing is correctly shimmed against the block. The small bracket is used to determine if the flywheel is seated properly on the…
Model: 3162975
Condition: NEW
Plier type tool used for forming split rivets to hold the cowl lacing to the firewall. Will NOT work on applications when you can't access the rivets on both sides such as 1926-27's. U.S.A.…
Model: 3149027
Condition: NEW
For setting solid rivets and giving them a rounded peen. It is best to set them hot. U.S.A.…
Model: 3130230
Condition: NEW
Easily snaps onto any standard aerosol spray can. The pistol grip transforms the aerosol can into a spray gun, offering excellent control and effortless continual spraying. It can be used with any aerosol product including paint…
Model: 3102204
Condition: NEW
Quickly disconnects electrical connectors without damage
The tool tip is double-ended to fit different access angles
Works on weather pack and other automotive electrical connectors
…
Model: 3135211
Condition: NEW
This little anvil clamps in a vise and makes riveting or removing old linings a snap! Kit comes with a punch to knock out old rivets, a tool to swedge new tubular rivets, and a tool to drill and countersink linings.…
Model: 3257230
Condition: NEW
Use when setting the timing, instead of the hand crank, makes the job easier, since you can rotate the crankshaft in both directions, helps to find top dead center.
USA made.
…
Model: 3233617
Condition: NEW
A copy of the KR Wilson tool used in rebuilding the Zenith carbs. Has female hex on both ends, used for the A-9538, A-9542, and A-9547-MB. U.S.A.…
Model: 3164026
Condition: NEW
Remove the rear axle nut & washer, screw on the knock-off tool & hit the end of the tool with a hammer to loosen the wheel.
…
Model: 3135896
Condition: NEW
Tool for peening the end of the body rivets. Fits any air hammer. U.S.A.…
Model: 3245595
Condition: NEW
Semi-circular tool that grabs the groove in the hub to free the hub from the axle. Ductile iron. 1928-31 U.S.A.…
Model: 3240357
Condition: NEW
It's called the traveling spreader since it is compact enough to take touring with you. This is used to spread the rear leaf spring. One end sets againts rolled end of spring and pipe goes around one of the housing bolts on the rear end…
Model: 3231888
Condition: NEW
Special tap for cleaning the jet threads in the Zenith carb. 5mm x .75 pitch. U.S.A.…
Model: 3229333
Condition: NEW
An easy to use gauge that verifies the brake shoe is making complete and even contact with the brake drum. This helps ensure your brake power is not being compromised. Mounts to front and rear spindle / hub. Instructions…
Model: 3209504
Condition: NEW
One of the handiest tools made for the Model T mechanic. Remove or replace sleeve without danger of twisting the sleeve out of shape. U.S.A.…
Model: 3191284
Condition: NEW
For adapting a modern compression tester to a stock Model A spark plug hole.
…
Model: 3162367
Condition: NEW
For 1932-34, removes the threaded plugs in the tie rod or drag link ends. Large screwdriver style blade on end. Use with 7/8" wrench.
…
Model: 3156493
Condition: NEW
This wooden stick is a copy of the original tool used to check the gasoline level.
…
Model: 3150133
Condition: NEW
This puller is for 1909-27 T's with wood wheels. Will not work on T's with wire wheels or TT (1-ton) trucks. Solid steel, not cast. U.S.A.…
Model: 3128503
Condition: NEW
This holds the camshaft when adjusting the cam screw, and has a Z bend making it easier to use. There is no need to remove the distributor body from the engine when using this wrench.
…
Model: 3127415
Condition: NEW
This heavy duty spring spreader spreads the rear leaf spring so it can be removed from the rear end.Minimum length 38" - Maximum length 56" U.S.A.…
Model: 3072303
Condition: NEW
For those rusted-in, corroded and hard to remove exhaust studs.…
