Scott Drakes 1964-66 Mustang Turn Signal Lever is a perfect copy of the original. Featuring fine chrome plating to replace those rusted or tweaked originals.
…
This plastic socket is used to hold the wire terminal ends firmly in place on the switch and is almost always brittle or broken when you go to replace it.
Installation is simple; carefully break apart the old socket with pliers…
Makes turn signal switch installation much easier with a new
connector as it is difficult to remove them from the original
switches. Same for both tilt wheel & non tilt.…
Makes turn signal switch installation much easier with a new
connector as it is difficult to remove them from the original
switches. Same for both tilt wheel & non tilt.…
Dearborn classics now offers correct style dash to engine gauge feed wiring harnesses. Made to match original design excatly. This harness connects the dashboard guages (from the firewall connector) to the engine compartment and sending…
Dearborn classics now offers correct style dash to engine gauge feed wiring harnesses. Made to match original design exactly. This harness connects the dashboard guages (from the firewall connector) to the engine compartment and sending…
This once hard-to-find part is now made by Scott Drake! This part makes installing the 68-69 Mustang turn signal switch easier. Made from translucent ABS plastic using the original Ford print.
…
Our wiring is constructed of modern materials that make it look like the original wiring that was on your classic Ford or vintage Mercury. Special molded plugs are reproduced so you can't tell our reproduction from the original.
…