This plastic socket is used to hold the wire terminal ends firmly in place on the switch and is almost always brittle or broken when you go to replace it.
Installation is simple; carefully break apart the old socket with pliers…
Keep your wiring secure and organized with this wire loom retainer, designed specifically for Ford cars and trucks. These factory-correct retainers ensure a precise fit and stable attachment, preventing wire movement and maintaining a…
Reproduction Of Original When replacing your sealed beam, check the socket for cracks or corrosion. If the socket is bad, replace it without replacing the entire wiring harness. This headlight bulb pigtail includes the socket & wires…
Keep your wiring harness secure with this 5-piece tape-on type retaining clip kit, designed specifically for 1979-2004 Ford Mustang models. These factory-correct clips ensure a precise fit and stable attachment, preventing wire movement…
Exact reproductions of originals!
In 67-68 Ford used red or brown connectors on different models,
the customer will need to check which color matches their headlight
harness plugs. .
For example:
1967 GT without tach used red extension…
We have the original style engine compartment and trunk ligh accessory kit that can be used on all 1960 through 1979 models Fords. Includes light with housing, wiring, and mounting hardware. This was an original part available from the…
This is a modern type coil wire that has the ends crimped in place so you're sure you have a good connection. Also has rubber boot installed. "Genuine Nu-Rex". U.S.A.…
Includes all loom straps, anchors, and clips necessary to correctly install wiring looms. These are excellent reproduction that feature excellent fit with concourse appearance. 25 piece kit
…
The black plastic inserts that go at the base of the headlamp where the wires butt together. This is what joins the contacts in your headlight sockets to the wires coming into the headlamp from your lighting wire harness.The headlamp…
The small wire ends that get crimped onto the wire ends to plug into the A-14487 wire connectors. These normally require a special wire crimping tool to install. I prefer to solder these in place instead. Strip about 1/4" of your wire, dip…
Includes all loom straps, anchors, and clips necessary to correctly install wiring looms. These are excellent reproduction that feature excellent fit with concourse appearance. 25 piece kit
…
Makes turn signal switch installation much easier with a new
connector as it is difficult to remove them from the original
switches. Same for both tilt wheel & non tilt.…
All the grommets you will need for the firewall. Fits 1928-31 with the exception of the late 1931 with the indented firewall for the fuel shut off valve.Includes ignition cable grommet @ terminal box, both styles of starter push rod…
Show Quality Pressure die-cast zinc bezels, with excellent triple chrome plating and black details are Concours quality. Constructed from pressure die-cast zinc, these bezels feature a triple chrome-plating finish and black details. These…
Reproduction Of Original When replacing your rusty or damaged fuel or brake lines, be sure to finish the job by replacing the mounting clips on the frame. This clip is reproduced just like the factory part with the correct phosphate…