Our patented Side Post Battery Disconnect switch is designed to be used with General Motors style batteries with the connections on the side. A simple twist of a knob provides a convenient way to quickly disconnect and reconnect…
Fully Automatic - Will keep your battery fully charged without over charging. The on-board microprocessor turns the charger on and off based on your battery's demands. It does so automatically, every few milliseconds.
Designed…
Original and reproduction battery trays. All of our battery trays are made of stamped steel and are painted factory black. Battery bolts are sold separately.
…
This OER® junction block serves as a connector to tie in your front headlamp harness to the small wiring lead leading from your positive battery cable. Once installed all of your cars power runs through this connector. Your car will…
Battery Tray - 7 X 12-1/4 - Top Clamp Type Replacement style battery tray used on 1966/1969 Fairlane and Torino big block, as well as 1969/1970 Galaxies is now available. This part is stamped steel and coated in black for correct finish…
Original and reproduction battery trays. All of our battery trays are made of stamped steel and are painted factory black. Battery bolts are sold separately.
…
Attach this to the battery post and when you leave the car, unscrew the knob. It is a good safety item that disconnects electrical current, eliminating theft, battery drain and fires.
…
Stamped steel battery tray used on 1961/1964 Galaxie big block models is now available. An accurate reproduction made in the original huge steel. Measures 7 x 15.
…
Strap attaches to right side fender brace and provides a sleeve for the hand crank handle to slide into. Keeps the hand crank from moving around. Made of black leather with a nickel buckle. U.S.A.…
Correct stamped steel battery tray hold down bracket for 1960/1966 models of Ranchero, Falcon and Comet with 40 and 45 amp batteries. Made to match the original Ford part exactly and finished in original semi-gloss black paint.
…
All terminals, boots, heads and mouldings have been duplicated with exacting details. The wire insulation is original neoprene rubber. The set includes positive, negative and starter cables. 1965 - 1969 cars also used a separate…
Original and reproduction battery trays. All of our battery trays are made of stamped steel and are painted factory black. Battery bolts are sold separately. Comes with lower brace. Fit's from 1/3/66 to 1969 with a 55amp alt. And it fits…
Original and reproduction battery trays. All of our battery trays are made of stamped steel and are painted factory black. Battery bolts are sold separately. Fits 260, 289 engines only. Will fit 6 cylinder engines without a/c. 6 cylinder…
1965 - 1969 cars used a separate ground strap that was used at the back of the engine head. 1970 and newer vehicles do not require this as a grounding tab is built into the negative cable.
…
Ford originally used this die stamped style battery hold down from August of 28 until May of 29, but it will work on all years. Very good quality! Powder coated black! U.S.A.INSIDE DIMENSIONS - 9.5" X 7.5"…
1965 - 1969 cars used a separate ground strap that was used at the back of the engine head. 1970 and newer vehicles do not require this as a grounding tab is built into the negative cable.
…
Welds to the frame. If your battery frame is still good but the bottom has rusted out, replace it with this plate.
Has square corners with two drain holes.
…