Features:
• 18½" Gallon Metal Tank
• In Cab Tank
• Without Emission Hole
• Requires a Vented Gas Cap
Dimensions:
Overall Measurements: Mounting Flange:
Length: 63" Width: 1¼"
Height: 18⅜" Top: 1¾"
Width: 6½" Bottom Sides: ⅞"
Note: Due to multiple suppliers, the product received could differ slightly from the picture displayed. Fit and Function is not affected.
Note: Requires Oversize Shipping
Ford In Cab 18½ Gallon Gas Tank for 1961-70 Ford Truck
Our Dennis Carpenter in-cab gas tanks are manufactured with quality steel to offer a good or better than the original reproduction. Due to the chemicals in gasoline and after years of being in service, gas tanks have a tenancy to rust on the inside which can cause a few different mechanical issues. One of the main issues caused is the fuel sender not sending the correct, if any, signal to the dash gauge. This leaves the driver not knowing the correct amount of fuel in the tank. The other issue is particles of rust can travel up to the carburetor, causing the carburetor to not function properly or leak.
This direct replacement, non-emission gas tank is installed in the cab, behind the seat. This tank comes with the strengthening recesses, is coated with a gray corrosion resistant paint, and comes with the extended bolt flanges for mounting.
Note: Our in cab as tank requires a vented gas cap and measures: 63” Long x 6½” Thick x 18⅜” Tall.
Dennis Carpenter Ford Restorations have been manufacturing and selling quality Ford parts for over 50 years!
If you want the very best in Ford truck parts let Dennis Carpenter be your #1 source.
Restore your classic beauty with a brand you can trust! Order our gas tank for your 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968, 1969 or 1970 Ford Truck.
As a family owned and operated company, Dennis Carpenter has been making Ford restoration parts for over 50 years. As a kid, Daniel Carpenter, Dennis's son, was at his dad's side when Dennis hand poured the first plastic dash knobs for a 1940 Ford convertible in an unfinished room in their home. The business was birthed, and soon thereafter, Dennis purchased his first injection molding machine for making large runs of higher quality knobs.
As the business grew, Dennis Carpenter Ford Restorations began manufacturing and selling rubber seals, rubber bumpers, die cast chrome parts and metal stamped parts. In 1998 Ford granted them the honor to use the original Ford factory tooling for many parts that they now manufacture. Today they have over 160 employees at their facility making and selling quality Ford parts. They now have 12 plastic injection molding machines, a rubber extruding operation, 54 rubber molding machines, 48 metal stamping presses, 2 zinc die casting machines, 3 roller mills and many other speciality machines for making quality parts in America.
| Make | Model | Years | Fitment Notes |
| Ford | F-100 | 1961 - 1970 | In Cab - - A1 |
| Ford | F-350 | 1961 - 1970 | In Cab - - A1 |
