Same as A-3527-BR except this has a tube welded to it to keep oil from leaking out the bottom of the steering box. these will not fit in all steering columns. Measure the ID of your steering shaft where this fits before you purchase it…
Exact reproduction of the original aluminum condenser. The original material and construction design is absolutely mandatory for proper system function and to prevent engine over-heating.
…
Exact reproduction of the original aluminum condenser. The original material and construction design is absolutely mandatory for proper system function and to prevent engine over-heating.
…
Used on the 7 tooth steering boxes to adjust the end play on the sector shaft. Kit includes the thrust screw and the thin jam nut that locks it down. U.S.A.…
Steering box is sand blasted, primed, assembled, adjusted. Rebuilt with all new internal parts. Bushings used on sector shaft. Includes spark/gas rods and upper bushing. Improved lower oil seal w/tube. Not included are A-3551-B lower…
Used on all 1928-29 7-tooth steering columns, nickle plated no countersink on spark / gas rod holes. Mounting holes must be drilled and tapped to 10/32 after pressing in place as Ford did originally. Mounting screws included. U.S.A.…
This bushing presses into the lower bearing assembly of the 7 tooth steering box. If the bottom of your steering shaft is worn, you can turn it down to true it and use this undersize bushing which has an I.D. of .615". USA…
Seals the steering sector shaft where the steering box attaches to the frame. Simply slide the O-ring over the end of the sector shaft, then the flat steel washer, then slide the steering box/sector housing up against the frame and draw…
This is an original pitman arm with a new ball installed. These are sold on exchange only and we must have your old pitman arm before we can ship out a rebuilt one. Must be free of oil and grease when you send your old one in. Left hand…
This set replaces the bushings in the sector housing. It will make the car steer much easier. The old sector housing must be machined out to a larger I.D. to accept these. It is a job for a machine shop. U.S.A.…
If when you turn your steering wheel, the light switch rod turns, this might be what you are missing. This sets in the tube that the light switch rod goes into and acts as a bushing, and spaces the rod away from the steering wheel. U.S.A.…
Connects between compressor and HVAC system to circulate refrigerant within the air conditioning systemMounts behind the grille in front of the engine's radiatorRestores functionality to an A/C system having a damaged condenser…
Original Equipment Quality Without Original Equipment Price
Direct Replacements For The Original Equipment
Imported
Manufacturer Limited Lifetime Warranty
NOTE:
Follow Manufacturer Removal And Installation Procedures Found…