Used on both the emergency brake and the service brake camshafts in the rear backing plate. A-2331-A and A-2636-A ride in these bushings. Use this part number for ordering individual bushings. U.S.A.…
Oversize brake rod clevis pins that are (.340") diameter. If you're clevises and brake rods have some wear, its best to drill them out using an 11/32" drill bit to accept these oversize pins. Use this part number for ordering individual…
For Cars With The High Performance Axle Using 7/16" Bolts
Includes Gaskets For Both Sides
Improved Materials Over Originals But Correct Appearance
Made In The USA
This gasket set includes four gaskets. The inner gaskets…
Correct Function And Appearance
A Very Nice Detail Item
Correct Bolt Included
Made In The USA
This Front Brake Line To Crossmember clip is often missing or damaged beyond repair. This faithful reproduction of the original comes with…
Faithful Reproduction Of Original
Two Required Per Car
Improved Materials Over Originals But Correct Appearance
Made In The USA
This gasket creates a seal between your front brake backing plate and the spindle. Each side had one…
This little anvil clamps in a vise and makes riveting or removing old linings a snap! Kit comes with a punch to knock out old rivets, a tool to swedge new tubular rivets, and a tool to drill and countersink linings.…
Quality Reproduction
Correct Size & Thread Pitch
Secures Bearing Cap
Made In The U.S.A.
These are the correct size nuts made to fasten and hold bearing caps. They feature correct thread pitch and an OEM…